WEDDING CHAMPAGNE "GROOM"

Send

A wedding is always a costly event, especially if you want to observe all the traditions and new-fangled trends. Often, even a business like buying wedding champagne in a store becomes a significant waste. But you can easily make it yourself. For example, I got such a friend.

For him I needed:
• Satin ribbons of medium thickness;
• glue;
• scissors;
• lighter;
• decorative flowers and half beads for decoration.
• champagne.

It is best to start from above, so the first thing we will do is a shirt collar. To do this, cut a small segment of a wide satin ribbon, fold it in half in this way and measure the required length.

Do not forget to scorch the edges with a lighter! Now, the half of the front side that will fit on the bottle is well lubricated with glue.

Glue so that the corners of the bend are in contact. The lower corners will subsequently close, so don't worry about them.

For further work, we will need tapes of medium width.

In order to measure the next segment, it is best to apply it over the collar.

The ends of the tape should overlap slightly on top of each other. Now we glue it directly under the fold of the upper tape, having previously bent the collar.

Thus, we seal the entire part of the bottle that the shirt occupies.

Tie turn. Having reviewed many MKs on this topic, I came to the conclusion that the best solution would be to tie up the most ordinary tie. Having measured the required length of the tape, I made a usual (or whatever it is called there) knot and smeared it with glue a little so that it would not move somewhere.

Since we will continue to glue tapes imitating a jacket, it is better to measure the length of the segment first before thoroughly sticking the tie to the bottle.

In this technique, we glue the entire part of the neck of the bottle until it stops expanding.

Now you need to slightly reduce the angle of the tape to make a smooth transition.

Then, glue one end of the tape to the bottle perpendicularly, a little glue with glue all the empty part of champagne and wrap it with tape.

Here is the result.

We begin to finish. To imitate the buttons of my jacket, I decided to choose heart-shaped half beads of gold color. Gently stick them on the glue.

And to the place where the pocket should be located, glue a flower. Boutonniere in place.

The groom is almost ready.

Now you need to build a cylinder so that the image is complete. To do this, I needed:
• A sheet of cardboard (you can cover the general notebook);
• felt-tip pen;
• glue;
• scissors;
• satin ribbons of medium width to match the jacket.

First of all, cut off the strip from the cardboard and glue its edges.

This will be the middle part of the cylinder. The main thing is that she sat well on the cork of the bottle. Now, having put the middle to the cardboard, draw two circles on it. The inner should be equal to the circumference of the middle part.

We need two such circles: one for the top, the other for the hat fields.

For clarity, I designated them H - bottom and B - top. We cut out the upper part and give it such a shape.

We combine the rays, grease with glue and place them inside the middle part.

We cut the lower part from the inside and bend the rays upward.

Now glue the rays to the middle part.

We start pasting the hat with ribbons. It is best to start this process from the fields. So in the end it will be possible to hide all the seams and imperfections.