Share
Pin
Tweet
Send
Share
Send
Pole and tip.
First you need to take a knife. If there are wooden or plastic overlays on his handle, then they need to be taken so that only the metal part remains. In my case, the knife was already without them. Next, try to put the back into the pipe. If she breaks in, then everything is fine. If it doesn’t fit in with me, then gently crush the pipe with a hammer to the length of the back of the knife. After that, insert the knife. Next, we put cotton in the gap between the pipe and the knife. This is necessary for compaction. You need to shove it very tight, otherwise the knife will dangle and may fall out. Next, we flatten the pipe with a hammer to finally fix the knife. Attention! It is not necessary to flatten the entire pipe, but only at the inserted part of the knife.
Handle.
In order for the spear to fly straight, and it was easy to throw, you need to take a few simple steps. First, balance it on the finger, and mark this place. Next, you need 2 pads on the steering wheel of the bike. Rubber linings are needed, and preferably in the size of the pipe. Next, you need to cut off that part of the lining that does not have a protrusion. The protrusion is where the little finger is when cycling. We do the same with the second overlay. Then we put both of them on the pipe, in that very marked place. Everything is ready.
How to throw. If you need to throw harder, then you need to take the handle with your fist, and if for accuracy, with three fingers, just like you hold the pen when writing. With a strong swing, the knife is stuck in the willow for 2 - 3 centimeters. You can also hunt hares or foxes with him. When hunting, it is better to climb a tree, so better accuracy is achieved.
Share
Pin
Tweet
Send
Share
Send