Share
Pin
Tweet
Send
Share
Send
Materials:
- Kapron tights
- Scissors
- Wire
- Beads
- Stack
- Thread
- Tape tape
Let's start:
To get started, we will make blanks for the flower, for this we cut off 25 centimeters of wire and wind it onto a stack, twisting the ends together.
Cut a piece of tights a little more than the workpiece. We put a ring of wire on the tights and tighten the workpiece with a capron.
Tie with strings or wire tight enough and cut off excess ends a little.
According to this principle, we make 4 more petals for one flower.
The middle is made of beads. To do this, cut the wire and string 4 beads, twist the wire and arrange the beads, as shown in the photo.
We collect our flower, if necessary, bend the petals a little. We twist all the ends of the wire.
In principle, the flower is ready, it remains only to decide what to do next. If you want to make a bouquet, then the wire can be wrapped with tape. If you want to make a brooch, then we wind the wire on a pin, at the end we cut off the excess wire.
Share
Pin
Tweet
Send
Share
Send